TP-Link JetStream T3700G-52TQ - Ip Igmp Startup-Query-Count; Ip Igmp Profile

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
T3700G-52TQ(config)# interface vlan 2
T3700G-52TQ(config-if)# ip igmp query-interval 10
41.11 ip igmp startup-query-count
Description
The ip igmp startup-query-count command is used to configure the number
of Startup Query Messages that the switch sends on specified interface. To
restore to the default value on this interface, please use no ip igmp
startup-query-count command.
Syntax
ip igmp startup-query-count count
no ip igmp startup-query-count
Parameter
count —— Specify the number of Startup Query Messages that the switch
sends, ranging from 1 to 20. The default value is 2.
Command Mode
Interface Configuration Mode
Example
Configure the number of Startup Query Messages that the switch sends as 3
on Interface VLAN 2:
T3700G-52TQ(config)# interface vlan 2
T3700G-52TQ(config-if)# ip igmp last-member-query-count 3
41.12 ip igmp profile
Description
The ip igmp profile command is used to create the configuration profile. To
delete the corresponding profile, please use no ip igmp profile command.
Syntax
ip igmp profile id
no ip igmp profile id
358