TP-Link JetStream T3700G-52TQ - Show Ip Multicast; Show Ip Mroute

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Interface Configuration Mode
Example
Configure the interval of Hello packet of 100s on VLAN interface 2:
T3700G-52TQ(config)# interface vlan 2
T3700G-52TQ(config-if)# ip pim hello-interval 100
42.12 show ip multicast
Description
The show ip multicast command is used to display the IP multicast
information.
Syntax
show ip multicast
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display ip multicast information:
T3700G-52TQ(config)# show ip multicast
42.13 show ip mroute
Description
The show ip mroute command is used to display the IP multicast routing
table.
Syntax
show ip mroute [ [ group ip-addr ] | [ source ip-addr ] | detail | static [ source
source-ip ] | [ summary ] ]
Parameter
group ip-addr —— Displays the multicast routing table with specified group
IP address.
373