JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
1.4.2 Special Characters
You should pay attentions to the description below if the variable is a character string:
These six characters ” < > , \ & cannot be input.
If a blank is contained in a character string, single or double quotation marks should be
used, for example ’hello world’, ”hello world”, and the words in the quotation marks will be
identified as a string. Otherwise, the words will be identified as several strings.
1.4.3 Parameter Format
Some parameters must be entered in special formats which are shown as follows:
MAC Address must be entered in the format of xx:xx:xx:xx:xx:xx.
One or several values can be typed for a port-list or a vlan-list using comma to separate.
Use a hyphen to designate a range of values, for instance 1,3-5,7 indicates choosing
1,3,4,5,7.
The port number should format as 1/0/3, meaning unit/slot/port. The unit number
represents the unit ID of the switch in the stack. The slot number is either 0 or 1, with 0
representing ports on the front panel and 1 representing the two ports on the Interface
Card inserted into the back panel. The port number is a variable (an actual value must be
assigned).
15
To Next Page
Loading...
