TP-Link JetStream T3700G-52TQ - Auto-Voip Dot1 P; Auto-Voip Dscp

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet )
Example
Set Auto VoIP VLAN 3 for port 3:
T3700G-52TQ(config)# interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)# auto-voip 3
52.3 auto-voip dot1p
Description
The auto-voip dot1p command is used to set the 802.1p priority of Auto
VoIP on specified ports.
Syntax
auto-voip dot1p dot1p
Parameter
dot1p ——Set the 802.1p priority of Auto VoIP on specified ports. It ranges
from 0 to 7.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet )
Example
Set Auto VoIP VLAN 3 for port 3:
T3700G-52TQ(config)# interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)# auto-voip 3
52.4 auto-voip dscp
Description
The auto-voip dscp command is used to set the DSCP value of Auto VoIP on
specified ports.
466