TP-Link JetStream T3700G-52TQ - Distance

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Example
Enable the auto computing function of the interface cost and configure the
reference bandwidth as 10000 Mbps:
T3700G-52TQ(config)# router ospf 1
T3700G-52TQ(config-router)# auto-cost reference-bandwidth 10000
46.9 distance
Description
The distance command is used to configure the OSPF administrative
distance. To restore to the default distance, please use the no distance
command. The administrative distance represents the priority of the routes.
The smaller administrative distance corresponds to higher priority. When
different routing protocols possess the same route to the same destination,
the route with the highest priority will be selected to add to the IP routing
table according to the administrative distance.
Syntax
distance administrative-distance
no distance
Parameter
administrative-distance —— Routing administrative distance, ranging from 0
to 255. Its default value is 110.
Command Mode
Router Configuration Mode
Example
Configure the OSPF routing administrative distance as 100:
T3700G-52TQ(config)# router ospf 1
T3700G-52TQ(config-router)# distance 100
405