TP-Link JetStream T3700G-52TQ - Snmp-Server Traps Ospf State-Change

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
all —— Enable all the retransmit traps.
packets —— Enable packet retransmission traps on non-virtual interfaces.
virt-packets ——Enable packet retransmission traps on virtual interfaces.
Command Mode
Global Configuration Mode
Example
Enable all the retransmit traps for the switch:
T3700G-52TQ(config)# snmp-server traps ospf retransmit all
35.13 snmp-server traps ospf state-change
Description
The snmp-server traps ospf state-change command is used to enable
state-change traps. To disable the sending of state-change traps, please use
no snmp-server traps ospf state-change command.
Syntax
snmp-server traps ospf state-change [ all | if-state-change |
neighbor-state-change | virtif-state-change | virtneighbor-state-change ]
no snmp-server traps ospf state-change [ all | if-state-change |
neighbor-state-change | virtif-state-change | virtneighbor-state-change ]
Parameter
all —— Enable all the state-change traps.
if-state-change —— Enable non-virtual interface state changes traps.
neighbor-state-change ——Enable non-virtual neighbor state changes traps.
virtif-state-change ——Enable virtual interface state changes traps.
virtneighbor-state-change ——Enable virtual neighbor state changes traps.
Command Mode
Global Configuration Mode
Example
Enable all the state-change traps for the switch:
T3700G-52TQ(config)# snmp-server traps ospf state-change all
301