JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
level
—— Severity level of the log information output to the terminal devices.
There are 8 severity levels marked with values 0-7. The smaller value has the
higher priority. Only the log with the same or smaller severity level value will
be output to the terminal devices. By default, it is 5 indicating that all the log
information between level 0-5 will be output to the terminal devices.
Command Mode
Global Configuration Mode
Example
Output the log information with severity levels between 0-7 to the terminal
devices:
T3700G-52TQ(config)# no logging monitor
18.11 clear logging
Description
The clear logging command is used to clear the syslog in the log buffer and
log flash in the specified unit or the whole stack.
Syntax
clear logging [ buffer | flash ] [ unit
unit-id
]
Parameter
buffer | flash —— The output channels: buffer and flash. Clear the information
of the two channels, by default.
unit-id
—— The unit in which the syslog will be cleared. If not specified, all the
syslog in the stack will be cleared.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Clear the syslog in the log buffer of all the switches in the stack:
T3700G-52TQ(config)#clear logging buffer
111
To Next Page
Loading...
