JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Delete the Gigabit Ethernet port 4 in monitor session 1 and its configuration:
T3700G-52TQ(config)#no monitor session 1 source interface
gigabitEthernet 1/0/4 rx
26.3 show monitor session
Description
The show monitor session command is used to display the configuration of
port monitoring.
Syntax
show monitor session [
session_num
]
Parameter
session_num
—— The monitor session number. The valid value is from 1 to 4.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the monitoring configuration of monitor session 1:
T3700G-52TQ(config)#show monitor session 1
214
To Next Page
Loading...
