TP-Link JetStream T3700G-52TQ - Logging File Flash Level; Logging Host

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
18.4 logging file flash level
Description
The logging file flash level command is used to specify the system log
message severity level. Only the log with the same or smaller severity level
value can be saved to the flash. To restore to the default level, please use no
logging file flash level command.
Syntax
logging file flash level level
no logging file flash level
Parameter
level —— Severity level of the log message. There are 8 severity levels
marked with values 0-7. The smaller value has the higher priority. Only the log
with the same or smaller severity level value will be saved to the flash. By
default, it is 1 indicating that the log message marked with 0-1 will be saved in
the log flash.
Command Mode
Global Configuration Mode
Example
Save the log messages with their severities equal or higher than 7 to the
flash :
T3700G-52TQ(config)#logging file flash level 7
18.5 logging host
Description
The logging host command is used to enable logging to a host. To disable
logging to a host, please use no logging host command.
Syntax
logging host
no logging host
107