JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 18 System Log Commands
The log information will record the settings and operation of the switch respectively for you to
monitor operation status and diagnose malfunction.
18.1 logging buffer
Description
The logging buffer command is used to store the system log messages to an
internal buffer. To disable the log buffer function, please use the no logging
buffer command. Local Log is the system log information saved in the switch.
It has two output channels, that is, it can be saved to two different positions,
log buffer and log flash memory. The log buffer indicates the RAM for saving
system log and the information in the log buffer can be got by
show logging
buffer command. It will be lost when the switch is restarted.
Syntax
logging buffer
no logging buffer
Command Mode
Global Configuration Mode
Example
Enable the system log buffer:
T3700G-52TQ(config)#logging buffer
18.2 logging buffer level
Description
The logging buffer level command is used to specify the severity level of the
log information that should be saved to the buffer. To return to the default
configuration, please use no logging buffer level command.
Syntax
logging buffer level
level
105
To Next Page
Loading...
