JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
35.2 snmp-server group
Description
The snmp-server group command is used to manage and configure the
SNMP group. To delete the corresponding SNMP group, please use no
snmp-server group command. SNMP v3 provides the VACM (View-based
Access Control Model) and USM (User-Based Security Model) mechanisms
for authentication. The users in the SNMP Group can manage the device via
the Read View, Write View and Notify View. And the authentication mode and
the privacy mode guarantee the high security for the communication
between the management station and the managed device.
Syntax
snmp-server group
name
[ smode { v1 | v2c | v3 }] [slev { noAuthNoPriv |
authNoPriv | authPriv }] [ read
read-view
] [ write
write-view
] [ notify
notify-view
]
no snmp-server group
name
smode { v1 | v2c | v3 } slev { noAuthNoPriv |
authNoPriv | authPriv }
Parameter
name
——The SNMP Group name, ranging from 1 to 16 characters. The
Group Name, Security Model and Security Level compose the identifier of the
SNMP Group. These three items of the Users in one group should be the
same.
smode —— Security Model, with v1, v2c and v3 options. They represent
SNMP v1, SNMP v2c and SNMP v3.
slev —— The Security Level of SNMP v3 Group. There are three options,
including noAuthNoPriv (no authorization and no encryption), authNoPriv
(authorization and no encryption) and authPriv (authorization and encryption).
By default, the Security Level is noAuthNoPriv. There is no need to configure
this in SNMP v1 Model and SNMP v2c Model.
read —— Read-only view. The management access is restricted to read-only,
and changes cannot be made to the assigned SNMP View.
write
—— Write-only view. The management access is writing only and
changes can be made to the assigned SNMP View. The View defined both as
the Read View and the Write View can be read and modified.
291
To Next Page
Loading...
