TP-Link JetStream T3700G-52TQ - Chapter 34 Static Multicast MAC Address Table Commands; Multicast Mac-Address-Table

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 34 Static Multicast MAC Address Table
Commands
Static multicast MAC address table allows you to create static multicast entries and view
Multicast Forwarding Database (MFDB) table information .
34.1 multicast mac-address-table
Description
The multicast mac-address-table command is used to configure the static
multicast table. To delete the configuration, please use no multicast
mac-address-table command.
Syntax
multicast mac-address-table mac-addr vid vlan-id [ interface | src-ports
interface ] { fastEthernet
port | gigabitEthernet port | ten-gigabitEthernet
port | port-channel lagid }
no multicast mac-address-table
mac-addr vid vlan-id [ interface | src-ports
interface ] { fastEthernet
port | gigabitEthernet port | ten-gigabitEthernet
port | port-channel lagid }
Parameter
mac-addr ——The multicast MAC address.
vlan-id —— VLAN ID, ranging from 1 to 4093.
port —— The port number.
lagid —— The ID of LAG.
Command Mode
Global Configuration Mode
Example
For Gigabit Ethernet port 2, create a static multicast entry that the MAC
address is 01:00:5e:00:00:01 and the VLAN ID is 1:
T3700G-52TQ(config)# multicast mac-address-table 01:00:5e:00:00:01 vid
1 interface gigabitEthernet 1/0/2
288