TP-Link JetStream T3700G-52TQ - Switchport Trunk Allowed Vlan

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
no switchport access vlan
Parameter
vlan-id —— Specify IEEE 802.1Q VLAN ID, ranging from 2 to 4093.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Configure Gigabit Ethernet port 1/0/3 whose link type is “access” to VLAN 2:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)#switchport access vlan 2
4.6 switchport trunk allowed vlan
Description
The switchport trunk allowed vlan command is used to add the desired
Trunk port to IEEE 802.1Q VLAN. To remove a Trunk port from the
corresponding VLAN, please use no switchport trunk allowed vlan
command.
Syntax
switchport trunk allowed vlan vlan-list
no switchport trunk allowed vlan vlan-list
Parameter
vlan-list —— VLAN ID list, ranging from 1 to 4093, in the format of 2-3, 5. It is
multi-optional.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Configure the link type of port 2 as trunk and add it to VLAN 2:
33