TP-Link JetStream T3700G-52TQ - Loopback-Detection Recovery-Time; Loopback-Detection(Interface)

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Global Configuration Mode
Example
Specify the interval-time as 50 seconds:
T3700G-52TQ(config)# loopback-detection interval 50
28.3 loopback-detection recovery-time
Description
The loopback-detection recovery-time command is used to configure the
time after which the blocked port would automatically recover to normal
status.
Syntax
loopback-detection recovery-time recovery-time
Parameter
recovery-time —— The time after which the blocked port would automatically
recover to normal status, and the loopback detection would restart. It is
integral times of detection interval, ranging from 1 to 100 and the default
value is 3.
Command Mode
Global Configuration Mode
Example
Configure the recovery-time as 3 times of detection interval:
T3700G-52TQ(config)# loopback-detection recovery-time 3
28.4 loopback-detection(interface)
Description
The loopback-detection command is used to enable the loopback detection
function of the specified port or LAG. To disable it, please use no
loopback-detection command.
218