JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 35 SNMP Commands
SNMP (Simple Network Management Protocol) functions are used to manage the network
devices for a smooth communication, which can facilitate the network administrators to
monitor the network nodes and implement the proper operation.
35.1 snmp-server view
Description
The snmp-server view command is used to add view. To delete the
corresponding View, please use no snmp-server view command. The OID
(Object Identifier) of the SNMP packets is used to describe the managed
objects of the switch, and the MIB (Management Information Base) is the set
of the OIDs. The SNMP View is created for the SNMP management station to
manage MIB objects.
Syntax
snmp-server view
name
mib-oid
{include | exclude}
no snmp-server view
name
mib-oid
Parameter
name
—— The entry name of View, ranging from 1 to 16 characters. Each
View can include several entries with the same name.
mib-oid
—— MIB Object ID. It is the Object Identifier (OID) for the entry of
View, ranging from 1 to 61 characters.
include | exclude —— View Type, with “include” and “exclude” options. They
represent the view entry can/cannot be managed by the SNMP management
station individually.
Command Mode
Global Configuration Mode
Example
Add a View named view1, configuring the OID as 1.3.6.1.6.3.20, and this OID
can be managed by the SNMP management station:
T3700G-52TQ(config)#snmp-server view view1 1.3.6.1.6.3.20 include
290
To Next Page
Loading...
