JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Example
Configure the filtering mode of profile 1 as permit:
T3700G-52TQ(config)# ip igmp profile 1
T3700G-52TQ(config-igmp-profile)#permit
41.15 range
Description
The range command is used to configure the range of the profile’s filtering
multicast address. To delete the corresponding filtering multicast address,
please use no range command.
Syntax
range
start-ip
[
end-ip
]
no range
start-ip
[
end-ip
]
Parameter
start-ip
—— The start filtering multicast IP address.
end-ip
—— The end filtering multicast IP address.
Command Mode
Profile Configuration Mode
Example
Configure one of the filter multicast address entry as range 225.1.1.1 to
226.3.2.1 in profile 1:
T3700G-52TQ(config)# ip igmp profile 1
T3700G-52TQ(config-igmp-profile)#range 225.1.1.1 226.3.2.1
41.16 ip igmp filter
Description
The ip igmp filter command is used to bind a profile to the specified VLAN
interface or routed port. To delete the profile-port binding entry, please use
no ip igmp filter command.
360
To Next Page
Loading...
