JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
31.14 ip igmp snooping querier query-interval
Description
The ip igmp snooping querier query-interval command is used to configure
the Query message interval time. The Querier will send General Query
Message with this interval. To return to the default configuration, please use
no ip igmp snooping querier query-interval command.
Syntax
ip igmp snooping querier query-interval
query-interval
no ip igmp snooping querier query-interval
query-interval
Parameter
query-interval
—— The Query message interval time, ranging from 1 to 1800
seconds. By default, it is 60 seconds.
Command Mode
Global Configuration Mode
Example
Configure the Query message interval time as 60 seconds:
T3700G-52TQ(config)#ip igmp snooping querier query-interval 60
31.15 ip igmp snooping querier timer expiry
Description
The ip igmp snooping querier timer expiry command is used to
configure the Expiry Interval which is amount of time the device remains in
non-querier mode after it has discovered that there is a multicast querier in
the network. To return to the default configuration, please use no ip igmp
snooping querier timer expiry command.
Syntax
ip igmp snooping querier timer expiry
timer-expiry
no ip igmp snooping querier timer expiry
Parameter
timer-expiry
—— The IGMP Querier timer expiration period, ranging from 60
to 300 seconds. By default, it is 125 seconds.
258
To Next Page
Loading...
