JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
mac-based: Any client connected to the port should pass the 802.1X
authentication for access.
port-based: All the clients connected to the port can access the network on
the condition that any one of the clients has passed the 802.1X
Authentication.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface ten-gigabitEthernet / interface range
ten-gigabitEthernet)
Example
Configure the Control Type for Gigabit Ethernet port 1/0/20 as “port-based”:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/20
T3700G-52TQ(config-if)#dot1x port-method port-based
17.11 dot1x accounting
Description
The dot1x accounting command is used to enable the accounting feature.
To disable the accounting feature, please use no dot1x accounting
command.
Syntax
dot1x accounting
no dot1x accounting
Command Mode
Global Configuration Mode
Example
Enable the accounting feature:
T3700G-52TQ(config)# dot1x accounting
103
To Next Page
Loading...
