JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
22.36 show boot
Description
The show boot command is used to display the current boot configuration of
the system.
Syntax
show boot
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the system boot configuration information of the switch:
T3700G-52TQ#show boot
22.37 show cable-diagnostics interface
Description
The show cable-diagnostics interface command is used to display the cable
diagnostics of the connected Ethernet Port, which facilitates you to check
the connection status of the cable connected to the Switch, locate and
diagnose the trouble spot of the network.
Syntax
show cable-diagnostics interface { fastEthernet
port
| gigabitEthernet
port
}
Parameter
port
—— The number of the port which is selected for Cable test.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Show the cable-diagnostics of Gigabit Ethernet port 20:
T3700G-52TQ#show cable-diagnostics interface gigabitEthernet 1/0/20
160
To Next Page
Loading...
