TP-Link JetStream T3700G-52TQ - Ipv6 Mld Snooping Max-Response-Time; Ipv6 Mld Snooping Drop-Unknown

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
32.8 ipv6 mld snooping max-response-time
Description
The ipv6 mld snooping max-response-time command is used to configure
the number of seconds the interface should wait after sending a query if it
does not receive a report for a particular group.
Syntax
ipv6 mld snooping max-response-time max-response-time
Parameter
max-response-time —— Specify the maximum responding time in seconds,
ranging from 1 to 25. The default aging time is 10 seconds.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Configure the maximum responding time as 15 seconds for Gigabit Ethernet
port 1/0/3:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)#ipv6 mld snooping max-response-time 15
32.9 ipv6 mld snooping drop-unknown
Description
The ipv6 mld snooping drop-unknown command is used to process the
unknown multicast as “discard”. To disable the operation of processing the
unknown multicast as “discard”, please use no ipv6 mld snooping
drop-unknown command.
Syntax
ipv6 mld snooping drop-unknown
no ipv6 mld snooping drop-unknown
Command Mode
Global Configuration Mode
Example
Specify the operation of processing unknown multicast as “discard”:
T3700G-52TQ(config)#ipv6 mld snooping drop-unknown
269