TP-Link JetStream T3700G-52TQ - Interface Ten-Gigabitethernet

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
port-list —— The list of Gigabit Ethernet ports.
Command Mode
Global Configuration Mode
User Guidelines
Command in the Interface Range gigabitEthernet Mode is executed
independently on all ports in the range. It does not affect the execution on the
other ports at all if the command results in an error on one port.
Example
To enter the Interface Range gigabitEthernet Configuration Mode, and
configure Gigabit Ethernet ports 10, 11 and 18 at the same time by adding
them to one port-list:
T3700G-52TQ(config)# interface range gigabitEthernet 1/0/10-11,1/0/18
23.3 interface ten-gigabitEthernet
Description
The interface ten-gigabitEthernet command is used to enter the interface
ten-gigabitEthernet Configuration Mode and configure the corresponding
Ten Gigabit Ethernet port.
Syntax
interface ten-gigabitEthernet port
Parameter
port —— The Ten Gigabit Ethernet port number.
Command Mode
Global Configuration Mode
Example
To enter the Interface gigabitEthernet Configuration Mode and configure
Ten-Gigabit Ethernet port 49:
T2700G-52TQ(config)#interface ten-gigabitEthernet 1/0/49
163