JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
32.13 ipv6 mld snooping querier query-interval
Description
The ipv6 mld snooping querier query-interval command is used to
configure the Query message interval time. The Querier will send General
Query Message with this interval. To return to the default configuration,
please use no ipv6 mld snooping querier query-interval command.
Syntax
ipv6 mld snooping querier query-interval
query-interval
no ipv6 mld snooping querier query-interval
query-interval
Parameter
query-interval
—— The Query message interval time, ranging from 1 to 1800
seconds. By default, it is 60 seconds.
Command Mode
Global Configuration Mode
Example
Configure the Query message interval time as 60 seconds:
T3700G-52TQ(config)#ipv6 mld snooping querier query-interval 60
32.14 ipv6 mld snooping querier timer expiry
Description
The ipv6 mld snooping querier timer expiry command is used to
configure the Expiry Interval which is amount of time the device remains in
non-querier mode after it has discovered that there is a multicast querier in
the network. To return to the default configuration, please use no ipv6 mld
snooping querier timer expiry command.
Syntax
ipv6 mld snooping querier timer expiry
timer-expiry
no ipv6 mld snooping querier timer expiry
Parameter
timer-expiry
—— The IGMP Querier timer expiration period, ranging from 60
to 300 seconds. By default, it is 60 seconds.
272
To Next Page
Loading...
