TP-Link JetStream T3700G-52TQ - Show Ip Route; Show Ip Route Specify

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Example
Display the summary information of the Layer 3 interfaces:
T3700G-52TQ(config)# show ip interface brief
37.12 show ip route
Description
This show ip route command is used to display the route entries of the
specified type.
Syntax
show ip route { static | connected | rip | ospf }
Parameter
static | connected | rip | ospf —— Specify the route type.
static: The static routes.
connected: The connected routes.
rip: The routes generated from the RIP protocol.
ospf: The routes generated from the OSPF protocol.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the static routes:
T3700G-52TQ(config)# show ip route static
37.13 show ip route specify
Description
This show ip route specify command is used to display the invalid routing
information to the specified IP address or network segments.
Syntax
show ip route specify { ip } [ mask ] [ longer-prefixes ]
326