TP-Link JetStream T3700G-52TQ - Reset; Reboot

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Interface Configuration Mode
Example
Enable the DHCP Client function on the Lay 3 routed port 1/0/1:
T3700G-52TQ(config)# interface gigabitEthernet 1/0/1
T3700G-52TQ(config-if)# no switchport
T3700G-52TQ(config-if)# ip address-alloc dhcp
Disable the IP address obtaining function on the VLAN interface 2:
T3700G-52TQ(config)# interface vlan 2
T3700G-52TQ(config-if)# no ip address
22.11 reset
Description
The reset command is used to reset the switch’s software. After resetting, all
configuration of the switch will restore to the factory defaults and your
current settings will be lost.
Syntax
reset
Command Mode
Privileged EXEC Mode
Example
Reset the software of the switch:
T3700G-52TQ#reset
22.12 reboot
Description
The reboot command is used to reboot the switch. To avoid damage, please
don’t turn off the device while rebooting.
Syntax
reboot [ unitid ]
146