TP-Link JetStream T3700G-52TQ - Chapter 23 Ethernet Configuration Commands; Interface Gigabitethernet; Interface Range Gigabitethernet

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 23 Ethernet Configuration Commands
Ethernet Configuration Commands can be used to configure the Bandwidth Control,
Negotiation Mode and Storm Control for Ethernet ports.
23.1 interface gigabitEthernet
Description
The interface gigabitEthernet command is used to enter the interface
gigabitEthernet Configuration Mode and configure the corresponding Gigabit
Ethernet port.
Syntax
interface gigabitEthernet port
Parameter
port —— The Gigabit Ethernet port number.
Command Mode
Global Configuration Mode
Example
To enter the Interface gigabitEthernet Configuration Mode and configure
Gigabit Ethernet port 20:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/20
23.2 interface range gigabitEthernet
Description
The interface range gigabitEthernet command is used to enter the interface
range gigabitEthernet Configuration Mode and configure multiple Gigabit
Ethernet ports at the same time.
Syntax
interface range gigabitEthernet port-list
162