TP-Link JetStream T3700G-52TQ - Show Storm-Control; Show Bandwidth

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
T3700G-52TQ(config)#show interface configuration gigabitEthernet 1/0/20
23.17 show storm-control
Description
The show storm-control command is used to display the storm-control
information of an Ethernet port.
Syntax
show storm-control interface [gigabitEthernet port | ten-gigabitEthernet
port | port-channel lagid ]
Parameter
port ——The port number or port list.
lagid —— The ID of LAG.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the storm-control information of port Gigabit Ethernet port 1/0/20:
T3700G-52TQ(config)#show storm-control interface gigabitEthernet 1/0/20
23.18 show bandwidth
Description
The show bandwidth command is used to display the bandwidth-limit
information of Ethernet port.
Syntax
show bandwidth interface [gigabitEthernet port | ten-gigabitEthernet port |
port-channel
lagid ]
Parameter
port ——The port number or port list.
lagid —— The ID of LAG.
173