TP-Link JetStream T3700G-52TQ - Switchport; Shutdown

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
port-channel-id —— The ID of the port-channel interface, ranging from 1 to
64.
Command Mode
Global Configuration Mode
Example
Create the port-channel interface 1:
T3700G-52TQ (config)# interface port-channel 1
37.5 switchport
Description
This switchport command is used to switch the Layer 3 interface into the
Layer 2 port. To switch the Layer 2 port into the Layer 3 routed port, please
use the no switchport command.
Syntax
switchport
no switchport
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Switch the gigabitEthernet port 1/0/9 into the routed port:
T3700G-52TQ(config)# interface gigabitEthernet 1/0/9
T3700G-52TQ(config-if)# no switchport
37.6 shutdown
Description
This switchport command is used to shut down the specified interface. The
interface type include: routed port, loopback interface and VLAN interface. To
enable the specified interface, please use the no shutdown command.
322