TP-Link JetStream T3700G-52TQ - Enable Authentication(Telnet); Line Ssh

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
T3700G-52TQ(config)#line telnet
T3700G-52TQ(config-line)# login authentication defaultList
48.16 enable authentication(telnet)
Description
The enable authentication command is used to apply the privilege
authentication method list to the telnet terminal line. To restore to the default
authentication method list, please use the no enable authentication
command.
Syntax
enable authentication { method-list }
no enable authentication
Parameter
method-list —— Specify the enable method list on the telnet terminal line. It is
“enableList” by default, which contains the priority 1 method “enable” and
priority 2 method “none”.
Command Mode
Line Configuration Mode
Example
Configure the enable authentication method list on the telnet terminal line as
“defaultList”:
T3700G-52TQ(config)#line telnet
T3700G-52TQ(config-line)# enable authentication defaultList
48.17 line ssh
Description
The line ssh command is used to enter the Line Configuration Mode to
configure the ssh terminal line to which you want to apply the authentication
list.
444