TP-Link JetStream T3700G-52TQ - Switchport Pvid; Switchport Trunk Native Vlan

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
4.8 switchport pvid
Description
The switchport pvid command is used to configure the PVID for the switch
General ports. To restore the PVID of the specified port as 1, please use the
no switchport pvid.
Syntax
switchport pvid vlan-id
Parameter
vlan-id —— Specify IEEE 802.1Q VLAN ID, ranging from 1 to 4093.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Specify the PVID of Gigabit Ethernet port 1/0/3 (General) as 1:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)#switchport pvid 1
4.9 switchport trunk native vlan
Description
The switchport trunk native vlan command is used to configure the PVID for
the switch Trunk ports. To restore the PVID of the specified port as 1, please
use the no switchport trunk native vlan.
Syntax
switchport trunk native vlan vlan-id
Parameter
vlan-id —— Specify IEEE 802.1Q VLAN ID, ranging from 1 to 4093.
35