TP-Link JetStream T3700G-52TQ - Ipv6 Mld Snooping Rtime; Ipv6 Mld Snooping Rtime(Interface)

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Example
Enable MLD Snooping function of Gigabit Ethernet port 23:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/23
T3700G-52TQ(config-if)#ipv6 mld snooping
32.3 ipv6 mld snooping rtime
Description
The ipv6 mld snooping rtime command is used to specify router port aging
time globally. To restore the default timer, please use no ipv6 mld snooping
rtime command.
Syntax
ipv6 mld snooping rtime rtime
no ipv6 mld snooping rtime
Parameter
rtime —— Specify the aging time in seconds, ranging from 0 to 3600. The
default aging time is 0 second.
Command Mode
Global Configuration Mode
Example
Specify MLD Snooping router port aging time as 100 seconds globally:
T3700G-52TQ(config)# ipv6 mld snooping rtime 100
32.4 ipv6 mld snooping rtime(interface)
Description
The ipv6 mld snooping rtime command is used to specify router port aging
time for the desired port. To restore the default timer, please use no ipv6 mld
snooping rtime command.
Syntax
ipv6 mld snooping rtime rtime
no ipv6 mld snooping rtime
Parameter
rtime —— Specify the aging time in seconds, ranging from 0 to 3600. The
default aging time is 0 second.
266