TP-Link JetStream T3700G-52TQ - Show Spanning-Tree Interface

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the bridge parameters:
T3700G-52TQ(config)#show spanning-tree bridge
30.24 show spanning-tree interface
Description
The show spanning-tree interface command is used to display the
spanning-tree information of all ports or a specified port.
Syntax
show spanning-tree interface [fastEthernet port | gigabitEthernet port |
ten-gigabitEthernet
port ] [edge | ext-cost | int-cost | mode | p2p | priority |
role | state | status]
Parameter
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the spanning-tree information of all ports:
T3700G-52TQ(config)#show spanning-tree interface
Display the spanning-tree information of Gigabit Ethernet port 1/0/2:
T3700G-52TQ(config)#show spanning-tree interface gigabitEthernet
1/0/2
Display the spanning-tree mode information of Gigabit Ethernet port 1/0/2:
T3700G-52TQ(config)#show spanning-tree interface gigabitEthernet
1/0/2 mode
247