TP-Link JetStream T3700G-52TQ - Ip Vrrp Vrid Virtual-Ip; Ip Vrrp Vrid Virtual-Ip (Secondary)

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
44.2 ip vrrp vrid virtual-ip
Description
This command is used to add a primary virtual IP for the virtual router. Each
virtual router has only one primary virtual IP which cannot be deleted.
Syntax
ip vrrp vrid vrid virtual-ip virtual-ip
Parameter
vrid —— The virtual router ID.
virtual-ip —— The IP address configured to the virtual router, which must be
in the same subnet with the interface.
Command Mode
Interface Configuration Mode
Example
Add a primary IP address as 192.168.0.7 for vrid 4 on interface VLAN 3:
T3700G-52TQ(config)#interface vlan 3
T3700G-52TQ(config-if)#ip vrrp vrid 4 virtual-ip 192.168.0.7
44.3 ip vrrp vrid virtual-ip (secondary)
Description
This command is used to add a secondary virtual IP for the virtual router. Up
to 32 IP addresses can be configured to a virtual router. To delete the
corresponding secondary virtual IP, please use no ip vrrp vrid virtual-ip
secondary command.
Syntax
ip vrrp vrid vrid virtual-ip virtual-ip secondary
no ip vrrp vrid
vrid virtual-ip virtual-ip secondary
Parameter
vrid —— The virtual router ID.
virtual-ip —— The IP address configured to the virtual router, which must be
in the same subnet with the interface.
382