TP-Link JetStream T3700G-52TQ - Mvr Vlan(Interface); Mvr Group

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
T3700G-52TQ(config)#mvr vlan 2
33.5 mvr vlan(interface)
Description
The mvr vlan command is used to set the MVR multicast VLAN for the
desired port. To return to the default configuration, please use no mvr vlan
command.
Syntax
mvr vlan vlan-id group ip-addr
no mvr vlan vlan-id group
ip-addr
Parameter
vlan-id —— VLAN ID, ranging from 1 to 4093.
ip-addr —— MVR group multicast IP address.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Set the MVR multicast VLAN as VLAN 2, MVR multicast group as 224.1.1.1 for
Gigabit Ethernet port 2 :
T3700G-52TQ(config)#interface gigabitEthernet 1/0/2
T3700G-52TQ(config-if)#mvr vlan 2 group 224.1.1.1
33.6 mvr group
Description
The mvr group command is used to create an MVR group. To delete the MVR
group, please use no mvr group command.
Syntax
mvr group ip-addr [ count ]
no mvr group
ip-addr [ count ]
Parameter
ip-addr —— The multicast group address.
283