TP-Link JetStream T3700G-52TQ - Boot Auto-Copy-Sw Trap; Switch Master

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Global Configuration Mode
Example
Enable downgrade of image on stack member:
T3700G-52TQ(config)# boot auto-copy-sw allow-downgrade
3.3 boot auto-copy-sw trap
Description
The boot auto-copy-sw trap command is used to enable stack firmware
synchronization traps. To disable stack firmware synchronization traps on
stack member, please use no boot auto-copy-sw trap command.
Syntax
boot auto-copy-sw trap
no boot auto-copy-sw trap
Command Mode
Global Configuration Mode
Example
Enable stack firmware synchronization traps:
T3700G-52TQ(config)# boot auto-copy-sw trap
3.4 switch master
Description
The switch master command is used to set the role of a specified switch in
the stack as master.
Syntax
swtich unitid master
Parameter
unitid —— Specify the member number.
23