JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
18.7 logging console
Description
The logging console command is used to send the system logs to the
console port. To disable logging to the console, please use no logging
console command. This function is enabled by default.
Syntax
logging console
no logging console
Command Mode
Global Configuration Mode
Example
Enable logging to the console port:
T3700G-52TQ(config)# logging console
18.8 logging console level
Description
The logging console level command is used to limit messages logged to the
console port. System logs no higher than the set threshold level will be
displayed on the console port. To restore the threshold level to default value,
please use no logging console level command.
Syntax
logging console level
level
no logging monitor level
Parameter
level
āā Severity level of the log information output to the console port.
There are 8 severity levels marked with values 0-7. The smaller value has the
higher priority. Only the log with the same or smaller severity level value will
be output to the terminal devices. By default, it is 5 indicating that all the log
information between level 0-5 will be output to the terminal devices.
109
To Next Page
Loading...
