TP-Link JetStream T3700G-52TQ - Speed; Storm-Control

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
23.10 speed
Description
The speed command is used to configure the Speed Mode for an Ethernet
port. To return to the default configuration, please use no speed command.
Syntax
speed { 10 | 100 | 1000 | 10000 | auto }
no speed
Parameter
10 | 100 | 1000 | 10000 | auto —— The speed mode of the Ethernet port.
There are four options: 10Mbps, 100Mbps, 1000Mbps, 10000Mbps and Auto
negotiation mode. By default, the gigabitEthernet port works in Auto
negotiation mode and the ten-gigabiteEthernet port works in 10000Mbps
mode.
Command Mode
Interface Configuration Mode (interface range gigabitEthernet / interface
ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Configure the Speed Mode as 100Mbps for Gigabit Ethernet port 20:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/20
T3700G-52TQ(config-if)#speed 100
23.11 storm-control
Description
The storm-control command is used to enable the broadcast, multicast and
unicast control functions. To disable the control function, please use no
storm-control command.
Syntax
storm-control { broadcast | multicast | unicast } { kbps | ratio | pps } { rate }
no storm-control
168