TP-Link JetStream T3700G-52TQ - Ipv6 Mld Snooping Mtime; Ipv6 Mld Snooping Mtime(Interface)

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Specify MLD Snooping router port aging time as 100 seconds for Gigabit
Ethernet port 1/0/3:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)#ipv6 mld snooping rtime 100
32.5 ipv6 mld snooping mtime
Description
The ipv6 mld snooping mtime command is used to specify member port
aging time globally. The default aging time is 260 seconds. To restore the
default timer, please use no ipv6 mld snooping mtime command.
Syntax
ipv6 mld snooping mtime mtime
no ipv6 mld snooping mtime
Parameter
mtime —— Specify the aging time in seconds, ranging from 2 to 3600. The
default aging time is 260 seconds.
Command Mode
Global Configuration Mode
Example
Specify MLD Snooping member port aging time as 100 seconds globally:
T3700G-52TQ(config)# ipv6 mld snooping mtime 100
32.6 ipv6 mld snooping mtime(interface)
Description
The ipv6 mld snooping mtime command is used to specify member port
aging time for the desired port. The default aging time is 260 seconds. To
restore the default timer, please use no ipv6 mld snooping mtime command.
Syntax
ipv6 mld snooping mtime mtime
no ipv6 mld snooping mtime
267