TP-Link JetStream T3700G-52TQ - Ip Pim Rp-Candidate Interface

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Global Configuration Mode
Example
Configure the candidate BSR on interface VLAN 2:
T3700G-52TQ(config)# ip pim bsr-candidate interface vlan 2 10 20 45
42.6 ip pim rp-candidate interface
Description
The ip pim rp-candidate interface command is used to configure the
candidate RP in specified multicast group. To disable the candidate RP in this
gorup, please use no ip pim rp-candidate interface command.
Syntax
ip pim rp-candidate interface { { fastEthernet | gigabitEthernet |
ten-gigabitEthernet }
port | vlan vlan-id } { group-address } { group-mask }
[ interval
interval ]
no ip pim rp-candidate interface { { fastEthernet | gigabitEthernet |
ten-gigabitEthernet }
port | vlan vlan-id } { group-address } { group-mask }
Parameter
fastEthernet | gigabitEthernet | ten-gigabitEthernet —— The port type of the
interface.
port —— The port number.
vlan-id —— The interface VLAN ID.
group-address —— The group address in which the candidate RP functions.
group -mask —— The mask of the multicast group.
interval —— The interval of RP advertisement interval. It ranges from 1 to 255
seconds.
Command Mode
Global Configuration Mode
Example
Configure the candidate RP on interface VLAN 2 in the multicast group
225.0.0.1/255.0.0.0 and the interval of RP advertisement interval as 70s:
369