JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Reboot with the backup image? (Y/N): y
22.21 firmware upgrade bootloader
Description
The firmware upgrade bootloader command is used to upgrade the uboot.
Syntax
firmware upgrade bootloader [
unitid
]
Parameter
unitid
—— Specify the member’s unit in the stack. If not specified, the uboot
of all the switches in the stack will be upgraded.
Command Mode
Privileged EXEC Mode
Example
Upgrade the uboot of all the switches in the stack:
T3700G-52TQ#firmware upgrade bootloader
22.22 firmware upgrade xmodem
Description
The firmware upgrade xmodem command is used to upgrade the switch’s
backup image file by xmodem.
Syntax
firmware upgrade xmodem
Command Mode
Privileged EXEC Mode
Example
Upgrade the switch’s backup image file by xmodem:
T3700G-52TQ# firmware upgrade xmodem
152
To Next Page
Loading...
