TP-Link JetStream T3700G-52TQ - Lldp Med-Fast-Count; Lldp Med-Status

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
36.7 lldp med-fast-count
Description
The lldp med-fast-count command is used to configure the number of the
LLDP-MED frames that will be sent out. When LLDP-MED fast start
mechanism is activated, multiple LLDP-MED frames will be transmitted based
on this parameter. The default value is 3. To return to the default
configuration, please use no lldp med-fast-count command.
Syntax
lldp med-fast-count count
no lldp med-fast-count
Parameter
count —— Configure the Fast Start Count parameter. It ranges from 1 to 10.
By default, it is 3.
Command Mode
Global Configuration Mode
Example
Specify Fast Start Count as 5:
T3700G-52TQ(config)# lldp med-fast-count 5
36.8 lldp med-status
Description
The lldp med-status command is used to enable the LLDP-MED feature for
the corresponding port. After the LLDP-MED feature is enabled, the port's
Admin Status will be changed to Tx&Rx. To disable the LLDP-MED feature for
the corresponding port, please use no lldp med-status command.
Syntax
lldp med-status
no lldp med-status
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
315