TP-Link JetStream T3700G-52TQ - Ipv6 Mld Snooping Immediate-Leave

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
mtime —— Specify the aging time in seconds, ranging from 2 to 3600. The
default aging time is 260 seconds.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Specify MLD Snooping member port aging time as 100 seconds for Gigabit
Ethernet port 1/0/3:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)# ipv6 mld snooping mtime 100
32.7 ipv6 mld snooping immediate-leave
Description
The ipv6 mld snooping immediate-leave command is used to configure the
Fast Leave function for the desired port. To disable the Fast Leave function,
please use no ipv6 mld snooping immediate-leave command.
Syntax
ipv6 mld snooping immediate-leave
no ipv6 mld snooping immediate-leave
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the Fast Leave function for Gigabit Ethernet port 1/0/3:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)#ipv6 mld snooping immediate-leave
268