TP-Link JetStream T3700G-52TQ - Chapter 52 Auto Voip Commands; Auto-Voip

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 52 Auto VoIP Commands
The Auto VoIP feature is used to prioritize the transmission of voice traffic. Voice over Internet
Protocol (VoIP) enables telephone calls over a data network, and the Auto VoIP feature helps
provide a classification mechanism for voice packets. When Auto VoIP is configured on a port
that receives both voice and data traffic, this feature can help ensure that the sound quality of
an IP phone does not deteriorate when data traffic on the port is heavy.
52.1 auto-voip
Description
The auto-voip command is used to enable the Auto VoIP function globally.
To disable the Auto VoIP function, use no auto-voip command.
Syntax
auto-voip
no auto-voip
Command Mode
Global Configuration Mode
Example
Enable the Auto VoIP function globally:
T3700G-52TQ(config)# auto-voip
52.2 auto-voip
Description
The auto-voip command is used to specify Auto VoIP VLAN ID for ports.
Syntax
auto-voip vlan-id
no auto-voip
Parameter
vlan-id ——Specify the Auto VoIP VLAN ID.
465