TP-Link JetStream T3700G-52TQ - Logging File Flash

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
no logging buffer level
Parameter
level —— Severity level of the log information output to each channel. There
are 8 severity levels marked with values 0-7. The smaller value has the higher
priority. Only the log with the same or smaller severity level value will be
output. By default, it is 6 indicating that the log information of levels 0 to 6 will
be saved in the log buffer.
Command Mode
Global Configuration Mode
Example
Set the severity level as 5:
T3700G-52TQ(config)#logging buffer level 5
18.3 logging file flash
Description
The logging file flash command is used to store the log messages in a file in
the flash on the switch. To disable the log file flash function, please use no
logging file flash command. The log file flash indicates the flash sector for
saving system log. The information in the log file of the flash will not be lost
after the switch is restarted and can be got by the show logging flash
command.
Syntax
logging file flash
no logging file flash
Command Mode
Global Configuration Mode
Example
Enable the log file flash function:
T3700G-52TQ(config)#logging file flash
106