TP-Link JetStream T3700G-52TQ - Ip Pim Dr-Priority

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
ip pim bsr-border
no ip pim bsr-border
Command Mode
Interface Configuration Mode
Example
Configure the BSR border on VLAN interface 2:
T3700G-52TQ(config)# interface vlan 2
T3700G-52TQ(config-if)# ip pim bsr-border
42.9 ip pim dr-priority
Description
The ip pim dr-priority command is used to configure the priority of DR. To
restore to the default value of DR priority, please use no ip pim dr-priority
command.
Syntax
ip pim dr-priority pri
no ip pim dr-priority
Parameter
pri —— Specify the priority of DR, ranging from 0 to 2147483647. The default
value is 1.
Command Mode
Interface Configuration Mode
Example
Configure the DR priority on interface VLAN 2 as 100:
T3700G-52TQ(config)# interface vlan 2
T3700G-52TQ(config-if)# ip pim dr-priority 100
371