TP-Link JetStream T3700G-52TQ - Passive-Interface Default; No Area

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
T3700G-52TQ(config-router)# passive-interface vlan 1
46.13 passive-interface default
Description
The passive-interface default command is used to prevent all the interfaces
from sending OSPF packets. To restore to the default settings, please use no
passive-interface default command. All the interfaces are allowed to send
OSPF packets by default.
Syntax
passive-interface default
no passive-interface default
Command Mode
Router Configuration Mode
Example
Prevent all the interfaces from sending OSPF packets in routing process 1:
T3700G-52TQ(config)# router ospf 1
T3700G-52TQ(config-router)# passive-interface default
46.14 no area
Description
The no area command is used to delete the specified area. Only areas
containing no networks can be deleted.
Syntax
no area area-id
Parameter
area-id ——The area ID, in the format of an IP address in dotted decimal
notation or decimal value ranging from 0 to 4294967295.
Command Mode
Router Configuration Mode
408