TP-Link JetStream T3700G-52TQ - Show Sdm Prefer Dual-Ipv4-And-Ipv6 Default; Show Sdm Prefer Ipv4-Routing

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
47.2 show sdm prefer dual-ipv4-and-ipv6 default
Description
The show sdm prefer dual-ipv4-and-ipv6 default command is used to
display parameters for the SDM template supports ipv4 routing and ipv6
routing.
Syntax
show sdm prefer dual-ipv4-and-ipv6 default
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display parameters for the SDM template supports ipv4 routing and ipv6
routing:
T3700G-52TQ(config)#show sdm prefer dual-ipv4-and-ipv6 default
47.3 show sdm prefer ipv4-routing
Description
The show sdm prefer ipv4-routing command is used to display parameters
for the SDM template supports ipv4 routing.
Syntax
show sdm prefer ipv4-routing {default | data-center default }
Parameter
default —— Display parameters for template with default bias.
data-center default
—— Display parameters for data center template.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display parameters for data center template:
T3700G-52TQ(config)#show sdm prefer ipv4-routing data-center default
432