TP-Link JetStream T3700G-52TQ - Ip Ospf Network

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
id —— The ID of the md5 authentication key, ranging from 1 to 255.
password —— A string from 1 to 16 alphanumeric characters or symbols.
The password is case sensitive, allows spaces but ignores leading spaces,
and cannot contain question marks. By default, it is empty.
Command Mode
Interface Configuration Mode
Example
Configure md5 authentication key ID as 1 and password as abc on interface
VLAN 2:
T3700G-52TQ(config)#interface vlan 2
T3700G-52TQ(config-if)# ip ospf message-digest-key 1 md5 abc
46.32 ip ospf network
Description
The ip ospf network command is used to configure the network type on the
specified interface. To restore to default, please use the no ip ospf network
command.
Syntax
ip ospf network { broadcast | point-to-point }
no ip ospf network
Parameter
broadcast —— The broadcast network type. It is the default value.
point-to-point —— The point-to-point network type.
Command Mode
Interface Configuration Mode
Example
Configure the network type on interface VLAN 2 as broadcast::
T3700G-52TQ(config)# interface vlan 2
422