TP-Link JetStream T3700G-52TQ - Ip Igmp Snooping Immediate-Leave; Ip Igmp Snooping Max-Response-Time

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Example
Specify IGMP Snooping member port aging time as 100 seconds for Gigabit
Ethernet port 1/0/3:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)# ip igmp snooping mtime 100
31.8 ip igmp snooping immediate-leave
Description
The ip igmp snooping immediate-leave command is used to configure the
Fast Leave function for the desired port. To disable the Fast Leave function,
please use no ip igmp snooping immediate-leave command.
Syntax
ip igmp snooping immediate-leave
no ip igmp snooping immediate-leave
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the Fast Leave function for Gigabit Ethernet port 1/0/3:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)#ip igmp snooping immediate-leave
31.9 ip igmp snooping max-response-time
Description
The ip igmp snooping max-response-time command is used to configure
the number of seconds the interface should wait after sending a query if it
does not receive a report for a particular group.
Syntax
ip igmp snooping max-response-time max-response-time
Parameter
max-response-time —— Specify the maximum responding time in seconds,
ranging from 1 to 25. The default aging time is 10 seconds.
254