TP-Link JetStream T3700G-52TQ - Chapter 33 MVR Commands; Mvr; Mvr(Interface)

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 33 MVR Commands
MVR (Multicast VLAN Registration) is intended to solve the problem of receivers in different
VLANs. It uses a dedicated manually configured VLAN, called the multicast VLAN to forward
multicast traffic over a Layer 2 network in conjunction with IGMP snooping.
33.1 mvr
Description
The mvr command is used to enable MVR function globally. To disable the
MVR function, please use no mvr command.
Syntax
mvr
no mvr
Command Mode
Global Configuration Mode
Example
Enable MVR function:
T3700G-52TQ(config)#mvr
33.2 mvr(interface)
Description
The mvr command is used to enable MVR function for the desired port. To
disable the MVR function for the desired port, please use no mvr command.
Syntax
mvr
no mvr
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable MVR function of Gigabit Ethernet port 2:
281