TP-Link JetStream T3700G-52TQ - Enable Password

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Example
Enable the global encryption function:
T3700G-52TQ(config)# service password-encryption
2.3 enable password
Description
The enable password command is used to set or change the password for
users to access Privileged EXEC Mode from User EXEC Mode. To remove the
password, please use no enable password command. This command uses
the symmetric encryption.
Syntax
enable password { [ 0 ] password | 7 encrypted-password }
no enable password
Parameter
0 —— Specify the encryption type. 0 indicates that an unencrypted password
will follow. By default, the encryption type is 0.
password —— Super password, a string from 1 to 31 alphanumeric
characters or symbols. The password is case sensitive, allows spaces but
ignores leading spaces, and cannot contain question marks. By default, it is
empty.
7 —— Indicates a symmetric encrypted password with fixed length will follow.
encrypted-password —— A symmetric encrypted password with fixed length,
which you can copy from another switch’s configuration file. After the
encrypted password is configured, you should use the corresponding
unencrypted password access Privileged EXEC Mode from User EXEC Mode.
Command Mode
Global Configuration Mode
User Guidelines
1. If the password you configured here is unencrypted and the global
encryption function is enabled in service password-encryption
, the
password in the configuration file will be displayed in the symmetric
encrypted form.
17